Monday, February 23, 2015

Continued Leg Work

All right, so it took me a little longer than I thought to find an opportunity to get back into the shop.  But finally I was able to get a little time in today, so here we go.................


Today I cut out the hole for the shoulder hub detail.  I made it 1/16th of an inch smaller than the piece itself to obtain a snug fit (honestly it measured really close to 3-3/8ths at the widest so I made it 1/16th smaller for good measure.  You can always sand off more, not less).  Of course I had to test fit the detail pieces that will go there.  Fits like a glove.


And while I was at it, I also drilled the 3/4" ankle bolt holes.

Next weekend I will focus on finishing the arm pits.

John